Canon 1130 Service Manual page 404

To use the SST, obtain a PC to which the SST (v1.32 or later) has been installed, and register
the firmware to the SST. Connect the PC to the machine using a parallel cable, and perform the
necessary work. The work from connecting the PC to bringing up the Job Selection screen is
common in downloading of firmware and uploading/downloading of backup data.
Downloading firmware
<Items to Prepare>
≥ PC
Be sure that the SST of v1.32 or later has been installed.
≥ Parallel Cable
Be sure that the cable is compatible with IEEE1284 (with the indication IEEE1284 Std
Compliant).
The length must be as short as possible while not affecting the work.
≥ Firmware
The files for the SST designed for the machine (DCON, JCON, MCON) must be ready.
COPYRIGHT © 2002 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
Registering firmware to the SST
Connecting the parallel cable
Starting and connecting the SST
Starting the Job Selection screen
Uploading backup data
Figure 9-202
CANON CLC1100/1130/1150/1160/1180 REV.0 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Downloading
backup data
9-2c