Canon 1130 Service Manual page 541

CHAPTER 11 INSTALLATION
16) Call the service station, and find out whether
initial settings work has ended. If it ended in
failure, start over by repeating steps 11)
through 13), i.e., from initializing the RAM,
and complete initial settings.
Be sure to find out whetehr
the
diagnostic
correct by referring to the
settings kept at the service
station.
17) Check to find out whether a call may be
placed to the computer at the service
station using the diagnostic device.
Press the push switch [18] (SW4) on the
PCB. In response, LED6 [24] (red) will turn
on: if the transmission ends successfully,
LED6 [24] (red) will turn off; if it ends in
failure, it will start to flash.
If you press the push switch SW4 [18]
while LED6 [24] is flashing, transmission
will occur once again.
If you press the push switch (SW1) [25]
while LED6 [24] is flashing, transmission
will be canceled.
18) Check to make sure that communication
between diagnostic device and copier is
normal.
Connect the copier's power plug, and turn
on the power switch to make user that
LED2 [26] (orange) flashes.
11-44
COPYRIGHT © 2002 CANON INC.
settings of the
device are
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
LED1 LED2 LED3
2
1
SW2
[24]
LED5
SW4
LED6
LED4
IC6
SW1
[25]
CN3
Figure 11-716
[26]
LED1 LED2 LED3
2
1
SW2
LED5
SW4
LED6
LED4
IC6
SW1
CN3
Figure 11-717
6
BAT1
1
1
SW3
2
CN4
[18]
CN2
6
BAT1
1
1
SW3
2
CN4
CN2