V.
INSTALLING THE
CONTROL CARD
UNIT-V
1. Mounting the Control Card Unit
1) Open the copier's front cover, and remove
the four screws [1] used to secure the
control panel in place.
2) Disconnect the two connectors (J901,
J961), and detach the control panel [2].
3) Remove the mounting screw [3] of the
face cover.
4) Disengage the claws [4], and detach the
face plate [5] from the card slot.
5) Attach the insulating sheet [6] over the
display opening for the control card unit
in the control panel.
6) Peel off the protective sheet from the
control card unit.
7) Secure the control card unit to the control
panel with four self-tapping screws [7].
At this time, insert a card into the control
card unit, and secure the control card unit
where the card may be slid in and out
easily.
Further, check to make sure that the
connector for the printer is centered in the
opening.
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
[1]
[2]
[1]
Figure 11-501
[4]
[5]
[4]
[6]
Figure 11-502
[7]
[7]
Figure 11-503
[3]
11-31