Canon 1130 Service Manual page 354

4) Remove the double-sided tape from the
leading edge (where holes are found) of
the transfer drum sheet.
5) By referring to the long hole in the left
side of the linking plate and the long hole
on the left side of the sheet, attach the
transfer drum sheet so that it is horizontal
while observing the following:
1. Fix the side of the trans-
2. Then, lightly pull the
3. At this time, check to
COPYRIGHT © 2002 CANON INC.
fer drum sheet with a
long hole temporarily in
place so that that the
gap between the left
side of the transfer
drum sheet and the edge
of the transfer ring is
about 0.5 mm.
transfer drum sheet to
the right so that the
middle of the sheet will
not become slack, and
attach the right side of
the sheet where a round
hole is found.
make sure that the right
edge of the transfer
drum sheet will not
overlap the edge of the
transfer ring; otherwise,
shift the left side of the
sheet where a long hole
is found, and start over
with step 2.
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP / FEEDING SYSTEM
Figure 7-846
Pull lightly to remove
the slack in the middle.
Transfer rings
Figure 7-846a
No overlapping.
7-91