Removing The Transfer Drum Assembly/Transfer Drum Frame; Removing The Transfer Drum - Canon 1130 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
A. Removing the Transfer
Drum Assembly/Transfer
Drum Frame

1. Removing the Transfer Drum

The one-way clutch is in
operation while the trans-
fer drum is on the transfer
drum frame. Do not rotate
the transfer drum while
keeping your fingers in an
opening of the transfer
drum.
The transfer drum, on the
other hand, will rotate in
reverse when it is off the
frame. Keep this in mid.
(Allowing it to rotate in re-
verse can damage the
transfer blade, attraction
brush, and transfer drum
side scraper.)
1) Open the hopper, and remove the transfer
drum frame cover; then, slide out the
transfer drum frame.
2) Disconnect the separation sensor
connector [1], three transfer drum
connectors [2], and polishing roller motor
connector [3].
7-74
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 7-801
[2]
[3]
Figure 7-802