Removing The Registration Roller - Canon 1130 Service Manual

6) Apply several drops of lubricating oil in
the gap [5] between the spring clutch gear
[3] and the control ring [4].
7) After applying oil, rotate the gear of the
spring clutch several times so that the oil
is spread through the gap between the gear
and the control ring; then, apply several
more drops of oil.
8) Repeat steps 6) and 7) so that as many as
ten drops of oil have been applied in total.
9) Wipe off any oil that has spread onto the
control ring.

7. Removing the Registration Roller

1) Remove the transfer drum and the fixing
assembly; then, detach the fixing
assembly frame from the copier.
2) Remove the attraction roll unit.
3) Disconnect the connector [1], remove the
screw [2], and remove the grip ring [3];
then, detach the registration clutch [4].
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP / FEEDING SYSTEM
[3]
Figure 7-820
Figure 7-821
[2]
Figure 7-822
[5]
[4]
(viewed from the front)
[4]
[3] [1]
7-81