Removing The No. 2 Blade - Canon 1130 Service Manual

1. Do not loosen any screws other than the screw [4] or [6] (CLC 1140/1160/
2. If you have replaced the black toner concentration sensor, replace the
3. If you have dry-wiped and mounted the black toner concentration sensor,
4. If you clean the black toner concentration sensor, use a flannel cloth,
5. If you have removed gradation sensor for cleaning, execute 'auto gradation

2. Removing the No. 2 Blade

1) Remove the black toner concentration
sensor unit from the copier.
2) Remove the two screws [1] (both front
and rear), and detach the No. 1 blade [2].
The No. 2 blade may be
used for both its sides (side
REF.
1, side 2). Mount it so that
the number (1, 2) on the
blade is visible from the
side of the photosensitive
drum.
COPYRIGHT © 2002 CANON INC.
[4]
Figure 6-675
[6]
Figure 6-675a
1180 only) shown in the figure to avoid displacing the sensor.
developer for all four colors, and make settings once again.
select and execute FUNCTION>
INSTALL>INIT-D in service mode.
moistened with and then well wrung.
The reason for using water is to remove charges from the sensor window.
(The presence of charges can attract toner to the sensor window)
After cleaning the sensor window with water, do NOT leave droplets of
water on it, also do NOT dry wipe it.
correction' in user mode. (CLC 1140/1160/1180 only)
CANON CLC1100/1130/1150/1160/1180 REV.0 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[4]
[2]
[1]
Figure 6-676
[2]
[1]
6-81b