Zero-Adjustment Of Input Coordinates - Canon 1130 Service Manual

CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
C. Zero-Adjustment of Input Coordinates
If you have replaced the editor controller PCB or the tablet, be sure to set the DIP switch on the
controller PCB according to the label attached to the cable of the tablet (Figure 9-603 and -604).
If a discrepancy still exists after setting the DIP switch, execute EDITOR>ADJUST>EDADJ-
X,Y in service mode.
9-16
COPYRIGHT © 2002 CANON INC.
Tablet
Label
Figure 9-603
1 2 3 4 5
Setting
(SW)ON
OFF
Figure 9-604
CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
6 7 8 9 10