Selecting A Call Channel - Icom IC-7100 Advanced Instructions
Hf/vhf/uhf all mode transceiver
Hide thumbs
Also See for IC-7100:
- Service manual addendum (294 pages) ,
- Instruction manual (197 pages) ,
- Basic manual (96 pages)
Table of Contents
Advertisement
Previous view
11
MEMORY OPERATION
Selecting a Call channel
Two Call channels (C1/C2) are selectable in each of the
144 and 430 MHz frequency bands.
Factory default frequencies and operating modes are
programmed into the Call channels. Change these to
suit your operating needs.
Select
the 144 or 430 MHz frequency band. (p. 3-6)
q
Push
(L) to select the Call channel of the
w
TUNER/CALL
selected frequency band.
• "CALL1" appears.
• Rotate [M-CH] to select "CALL2."
Push
(L) again to return to the previous
e
TUNER/CALL
screen display.
TUNER/CALL
While in the Call channel mode
11-4
Appears
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the IC-7100 and is the answer not in the manual?
Questions and answers
IC-7100 is two months old. Power suddenly cut off. Fuses are OK. No obvious damage internally. Can something with the control head cause unit not to power up?
Yes, a control head issue can cause the Icom IC-7100 to not power up. The control head receives power through the extension cable with shielded RJ45 connectors. If there is high resistance in the power wires or a poor connection in the umbilical cable, it may prevent the control head from receiving enough power to function properly. Reseating both connectors may help resolve the issue.
This answer is automatically generated