Selecting A Call Channel; Entering A Memory/Call Channel - Icom IC-V3500 Advanced Manual

MEMORY OPERATION
3�

Selecting a Call channel

The factory default frequency is entered in the Call
channel�
z Repeatedly push [M/CALL PRIO] to select the Call
channel�
• A "C" is displayed.
L Push [M/CALL PRIO] again to select the Memory
mode, or push [V/MHz SCAN] to select the VFO
mode�
NOTE: When the VFO mode is selected from the
Call channel, a small "c" is displayed instead of the
Memory channel number�
Using the HM-133V microphone
z Hold down [MR/CALL] for 1 second to select the
Call channel�
L Push [MR/CALL] to select the Memory mode, or push
[VFO/LOCK] to select the VFO mode.

Entering a Memory/Call channel

The VFO settings, including the Set mode contents,
such as subaudible tone frequency and so on, can be
entered into a Memory or Call channel�
1� Set the frequency in the VFO mode.
L If desired, set other data (Example: frequency offset,
duplex direction, and tone squelch)�
2� Push [S.MW MW] to enter the Memory Write
mode�
• " " and the Memory channel number blink�
3� Rotate [DIAL] to select a Memory or Call channel.
L If the selected Memory channel is blank, only the
Memory channel number is displayed�
4� Hold down [S.MW MW] for 1 second to write.
• Three beeps sound�
L The Memory channel number automatically increases
when holding down [S.MW MW] after writing.
NOTE: You can also set a Memory channel in other
ways�
Example: Entering the Memory contents to a different
Memory channel or the Call channel�
(p� 3-7)
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
Call channel
Example: Entering 145.870 MHz to Memory
channel 20.
Set the frequency in the VFO mode.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Push [S.MW MW] to enter the Memory Write mode.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Rotate [DIAL] to select Memory channel 20.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Hold down [S.MW MW] for 1 second to write.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
3-4
"C" is displayed�
PRIO SCAN
M/CALL V/ MHz
PRIO SCAN
V/ MHz
" " and the Memory Channel
number blink�
PRIO SCAN
V/ MHz
PRIO SCAN
V/ MHz
3 beeps sound�
PRIO SCAN
V/ MHz