Selecting A Call Channel; Entering Memory Channels - Icom IC-T10 Advanced Manual

2
MEMORY OPERATION

Selecting a Call channel

Call channels are used for quick recall of most often
used operating frequencies.
1. Repeatedly push [V/M/C] to select the Call
Channel mode.
2. Push [BAND] to toggle between the VHF call
channel and UHF call channel.

Entering Memory channels

Example: Entering 145.800 MHz into Channel 11
1. Repeatedly push [V/M/C] to select the VFO mode.
2. Repeatedly push [BAND] to select the VHF band.
3. Set the frequency to 145.800 MHz.
4. Push [S.MW] until two short beeps sound.
• " " and the channel number blink.
L Holding down even after two short beeps sound
writes the set frequency to the currently selected
channel.
5. Rotate [DIAL] to select Channel 11.
6. Push [S.MW] until two short beeps sound to enter
145.800 MHz to Channel 11.
• The transceiver returns to the VFO mode.
TIP: About the Auto Increment
When entering the frequency to the Memory
Channel in Step 6, hold down [S.MW] until three
beeps sound, to write to the previous channel of the
selected channel.
2-3