Icom IC-7100 Advanced Instructions page 4

Hf/vhf/uhf all mode transceiver
Hide thumbs Also See for IC-7100:
Table of Contents

Advertisement

Previous view
INTRODUCTION
About the touch screen
The following functions and features can be used with Adobe
Touch operation
D
A brief touch
If the monitor is touched briefly, a beep sounds.
D
Touch for 1 second
If the monitor is touched for more than 1 second, a
beep sounds.
• The operation is enabled as the beep sounds.
What to touch
The following functions can be touched to operate.
• See each function's instructions for further details.
Frequency
Frequency
(MHz)
(kHz)
Operating
mode
Touch key for each function.
(Example: M-1 menu is selected.)
Frequency
(Hz)
Filter No.
VFO mode/
Memory mode
Meter type
®
Reader
®
.
D Touch screen precautions
Briefly touching the controller's touch operates the
function.
• The touch screen may not properly work when LCD protec-
tion film or sheet is attached.
• Touching the screen with finger nails, sharp topped object
and so on, or touching the screen hard may damage the
screen.
• Tablet PC's operations such as flick input, pinch in and
pinch out cannot be performed with this touch screen.
D Touch screen maintenance
• If the touch screen becomes dusty or dirty, wipe it clean
with a soft, dry cloth.
• When you wipe the touch screen, be careful not to push it
too hard or scratch it with finger nails. Otherwise you may
damage the touch screen.
iii

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IC-7100 and is the answer not in the manual?

Questions and answers

William Carpenter
January 26, 2025

IC-7100 is two months old. Power suddenly cut off. Fuses are OK. No obvious damage internally. Can something with the control head cause unit not to power up?

1 comments:
Mr. Anderson
February 10, 2025

Yes, a control head issue can cause the Icom IC-7100 to not power up. The control head receives power through the extension cable with shielded RJ45 connectors. If there is high resistance in the power wires or a poor connection in the umbilical cable, it may prevent the control head from receiving enough power to function properly. Reseating both connectors may help resolve the issue.

This answer is automatically generated

Table of Contents

Save PDF