Start To Record When The [Ptt] Switch Is Pushed - Icom IC-7100 Advanced Instructions

Previous view
14
VOICE MEMORY FUNCTION

Start to record when the [PTT] switch is pushed

The transceiver starts to record the transmitted audio
when the [PTT] switch is pushed.
After transmitting, when the transceiver receives a sig-
nal in a given amount of time, it also records the re-
ceived audio. Therefore, you can record all communica-
tion audio using this function.
Push (C) to enter the Set mode.
q
SET
Touch the "PTT Auto REC" item of the "Voice Memo"
w
Set mode.
( Voice Memo > QSO Recorder > Recorder Set >
PTT Auto REC)
• If the specified item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch "ON."
e
• OFF : The transceiver does not start to record when the
[PTT] switch is pushed.
• ON : The transceiver starts to record when the [PTT]
switch is pushed.
Push (C) to exit the Set mode.
r
SET
NOTE: When you set PTT AUTO REC to ON, see
the notes below.
• The transceiver also starts to record audio when
the optional microphone's [PTT] switch is pushed,
transmitting using the VOX function or the CI-V re-
mote controller.
• All transmit audio is recorded.
( When "RX Only" is set in the "REC Mode" item,
transmit audio is not recorded)
• When the transceiver receives a signal less than
10 seconds after transmitting, the transceiver also
records the receive audio.
• In addition, when the transceiver receives a signal,
and then receives other signals less than 10 sec-
onds later, it records all signals audio.
L eft D isplay
C enter
14-11
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
SET
Touch
"Voice Memo."
Touch
"QSO Recorder."
Touch
"Recorder Set."
Touch
"PTT Auto REC."
Touch
"ON."