Emr Communication - Icom IC-7100 Advanced Instructions
Hf/vhf/uhf all mode transceiver
Hide thumbs
Also See for IC-7100:
- Service manual addendum (294 pages) ,
- Instruction manual (197 pages) ,
- Basic manual (96 pages)
Table of Contents
Advertisement
Previous view
9
D-STAR OPERATION <ADVANCED>
EMR communication
The EMR (Enhanced Monitor Request) communication
mode can be used in only the DV mode. In the EMR
mode, no call sign setting is necessary.
All transceivers that receive an EMR mode signal auto-
matically open their squelch to receive the signal.
When an EMR mode signal is received, the audio (voice)
will be heard at the specified level, even if the volume
setting level is set to the minimum level, or digital call
sign/digital code squelch is in use. (Default: OFF)
NOTE: The EMR communication function is auto-
matically turned OFF when the transceiver is turned
OFF.
Push
(C) to enter the DR mode.
q
DR
• The DR mode is selected.
Touch the "FROM" field.
w
• The "FROM SELECT" screen appears.
Touch "Repeater List."
e
• The "REPEATER GROUP" screen appears.
Touch the repeater group where your access repeat-
r
er is listed.
• Example: "11: Japan"
Touch your access repeater.
t
• Example: "Hamacho"
• "Hamacho" is displayed in "FROM."
Push
(C) to enter the Set mode.
y
SET
Touch the "EMR" item of the DV SET Set mode.
u
DV Set > EMR
• If the specified item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch "ON."
i
Push
(C) to exit the Set mode.
o
SET
• "EMR" appears.
!0 Push [PTT] on the microphone or switch ON the ex-
ternal TX switch to transmit.
• The TX/RX indicator lights red.
• "EMR" blinks on a station that receives the EMR signal.
The audio (voice) will be heard at the specified level, or
the [AF]
(L) control level, whichever is higher.
!1 Release [PTT] or Switch OFF the external TX switch
to receive.
!2 To cancel the EMR mode, select "OFF" in step i, as
described above, or turn OFF the power.
L eft
D isplay
R ight
C enter
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Example: To transmit from the "Hamacho" repeater in
the EMR mode
Appears
9-10
Touch
"DV Set"
Touch
"EMR"
Touch
"ON"
Push
SET
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the IC-7100 and is the answer not in the manual?
Questions and answers
IC-7100 is two months old. Power suddenly cut off. Fuses are OK. No obvious damage internally. Can something with the control head cause unit not to power up?
Yes, a control head issue can cause the Icom IC-7100 to not power up. The control head receives power through the extension cable with shielded RJ45 connectors. If there is high resistance in the power wires or a poor connection in the umbilical cable, it may prevent the control head from receiving enough power to function properly. Reseating both connectors may help resolve the issue.
This answer is automatically generated
re ICOM 7100. Digital mode operations leave the mike path inoperable. What protocols are required on the DV USB computer/transceiver cable? Transceiver control head display shows USB-D when the intent is USB.