Developer drive assembly removal
Remove the system board and inner shield. See
1.
page
4-77.
Remove the two short screws (A) and the one long screw (B) securing the developer drive assembly.
2.
Remove the developer drive assembly.
3.
Remove the developer drive coupler kit. See
4.
Installation
Place the developer coupler into the main motor drive shaft.
1.
Place the developer drive shaft on the developer drive.
2.
Align the developer drive shaft with the coupler.
3.
Be sure to replace the screws in the same positions.
4.
"System board and inner shield removal" on
"Developer drive coupler kit removal" on page
4-26.
Repair information
4-25