Removal 15 FEED DRIVE ASSEMBLY (PL8.1.7)
Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 12)
4)
Remove the RIGHT COVER. (Removal 13)
5)
Remove the SPRING FEED MSI (PL3.1.4) from the printer.
6)
Remove the GEAR MSI from the SHAFT MSI (PL3.1.12) by releasing the hook on the GEAR
MSI (PL3.1.5).
7)
Remove all the harnesses from the DUCT DRV PH (PL8.1.8).
Continues to the next page.
Version 2 2006.03.31
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-1
3 - 26
5)
6)-2
Kmy03017KB