Table of Contents
Advertisement
®
™
Dialogic
BorderNet
500 Gateways Installation and Configuration Guide
Overview of Configuring the Dialogic
Before you start to configure your BorderNet 500 Gateway, it is necessary to gather the following information
if the gateway will be connected to a PBX:
• The PBX vendor and type of PBX that will be used.
• The protocol that will be used on the PSTN/PBX side of the gateway. Examples are EuroISDN (ETSI-DSS1),
Q-SIG, and DMS100.
It is also important to understand the overall configuration process, as described below.
SIParator Software Settings
• The BorderNet 500 Gateway uses two sets of SIParator software configurations:
•
Preliminary configuration, which is the configuration you work with when you configure the SIParator. As
you change the preliminary configuration, the permanent configuration continues to control the SIParator
functions.
• Permanent configuration, which controls the SIParator functions while the SIParator is running.
• Most changes you make in the preliminary configuration are not stored in the permanent configuration until
you apply them, as described in
and time setting are the exceptions to this rule; they are saved immediately.
• The SIParator software displays serious errors in red; for example, if mandatory information is not entered.
Blank fields are also shown in red. Fields that you correct remain red until you click Save or Add new rows,
or you update the configuration page in some other way.
• If you have a web session with the SIParator that is inactive for 10 minutes, it will ask for a password again.
• Always log out from the SIParator administration interface when you are not using it. Click Log out on the
top right of the configuration page to log out.
For more information about preliminary and permanent configurations and an explanation of the terms used in
this guide, see the Dialogic
Accessing the SIParator Software Web Interface Directly from a Browser
To access the SIParator Software Web Interface directly from a browser, follow these steps:
1. Enter the IP address of the BorderNet 500 Gateway in the location box of your web browser.
2. Enter either your administrator username and password or the RADIUS username and password. The default
administrator is admin, and the password is the password specified during installation.
Page 22
®
BorderNet™ 500 Gateway
Applying the SIParator Configuration
®
TM
BorderNet
500 Gateways Reference Guide.
on page 35. The password configuration
Advertisement
Table of Contents
