Configuration - Fujitsu MB95630H Series Hardware Manual

MB95630H Series
27.2

Configuration

The comparator module consists of the following blocks:
• Comparator
• Edge detection circuit
• Comparator control register
■ Block Diagram of Comparator
Interrupt request
To the external pin control circuit
(When CMPn_P and CMPn_N
analog input is enabled (VCID = 0),
the corresponding GPIO input and
output is disabled.)
(From an external pin) CMPn_P
(From an external pin)
CMPn_N
MN702-00009-1v0-E
Figure 27.2-1 Block Diagram of Comparator
Comparator control register (CMR0C)
- - OS
+
−
FUJITSU SEMICONDUCTOR LIMITED
CHAPTER 27 COMPARATOR
IF IE VCID VCOE PD
Edge detection
circuit
Comparator
27.2 Configuration
To the external pin
control circuit
(Enable CMPn_O output
via an external pin)
CMPn_O (To an external pin)
591