When One-Shot Position Detection Or Reload Timer Underflow - Fujitsu MB95630H Series Hardware Manual

8-bit microcontroller new 8fx

Hide thumbs Also See for MB95630H Series:

Table of Contents

CHAPTER 21 MULTI-PULSE GENERATOR

21.5 Operations

When One-shot Position Detection or Reload

Timer Underflow

The output timing change of the operation of the one-shot position detection or

reload timer underflow is shown in Figure 21.5-24. This operation mode is

selected by setting the OPS[2:0] = 0b101.

■ When One-shot Position Detection or Reload Timer Underflow

The operation of one-shot position detection or reload timer underflow is the same as that of

the position detection or reload timer underflow, except that after the first valid position is

detected, no further position detection is recognized until the operation mode is changed from

one-shot position detection or reload timer underflow to another operation mode.

The OPTx output waveform is shown as in Figure 21.5-24.

■ Timing Generated by One-shot Position Detection or Reload Timer Underflow

(OPS[2:0] = 0b101)

Figure 21.5-24 Timing Generated by One-shot Position Detection or Reload Timer Underflow

(OPS[2:0] = 0b101)

FUJITSU SEMICONDUCTOR LIMITED

MB95630H Series

MN702-00009-1v0-E