Fujitsu MB95630H Series Hardware Manual page 39

8-bit microcontroller new 8fx

Hide thumbs Also See for MB95630H Series:

Table of Contents

MB95630H Series

● System clock control register 2 (SYCC2)

This register is used to enable/disable the oscillations of the main clock, main CR clock,

subclock, and sub-CR clock, and to display the ready signals of main clock oscillation,

subclock oscillation, sub-CR oscillation and main CR oscillation.

● Oscillation stabilization wait time setting register (WATR)

This register is used to set the oscillation stabilization wait time for the main clock and

● Standby control register 2 (STBC2)

This register is used to control the deep standby mode.

MN702-00009-1v0-E

FUJITSU SEMICONDUCTOR LIMITED

CHAPTER 3 CLOCK CONTROLLER

3.1 Overview