Printer Head - Muratec MFX-2550 Field Engineering Manual

PRINTER HEAD

1. Remove the Cover connect. (See COVER CONNECT)
2. Remove the Cover option. (See COVER OPTION)
3. Remove the Cover shield. (See COVER SHIELD)
4. Remove the Cover back. (See COVER BACK)
5. Remove the Chassis FBS. (See PCB CONNECT LPH)
6. Open the Cover jam access. (See ASSY INTERLOCK)
7. Remove the Cover left. (See PCB NCU)
8. Remove the Tray paper exit. (See PCB CONNECT LPH)
9. Open the Cover front, then remove the developer and the drum. (See COVER FRONT)
10. Pull out the Film harness [1].
11. Remove two screws [2], then disconnect the Ground wires [3].
12. Remove two screws [4], then remove the Stay LED [5] and the Bracket LED [6].
[ 2 ]
[ 3 ]
[ 4 ]
[ 5 ]
[ 2 ]
[ 3 ]
[ 4 ]
[ 1 ]
[ 6 ]
5-116