Muratec MFX-2550 Field Engineering Manual page 221

Detail
Phase Error code
Error code
Tx Phase B T.2.2 110E
110F
1110
1111
1112
1113
1114
1115
1116
T.2.3 1023
Tx Phase C T.3.1 1031
Tx Phase D T.4.1 1041
T.4.2 1042
T.5.1 1051
T.5.2 1052
T.5.3 1053
Tx V34 start up T.8.1 1081
1800
1801
1802
1803
T.8.10 108A
T.8.11 108B
Transmission T.1.4 1014
canceled
Description
The receiver has no box with matching
Yes
sub-address
The receiver has no box that matches
with the sender
No document stored at polling in the
designated box
The receiver tried to poll document in a
security box
Polling rejected while receiving docu-
ment on another line at multi line recep-
tion
Polling rejected while storing or clearing
documents
Polling rejected while printing docu-
ments
Cannot fast remote diagnose
Trouble report was sent, but the receiver
was not a diagnose host
FTT returned at 2400 bps
Document feeding error Yes
Document length was over 1m
Lamp error
Scanner cover open error
Cannot receive MCF/RTN/RTP/PIP/PIN Yes
RTN was received
No response to RR
No response to CTC
EOR output
V8 process did not finished normally Yes
Primary channel instruction did not
match at V8 mode
Primary channel instruction did not
match at V8 mode (TX FAX)
Primary channel instruction did not
match at V8 mode (RX FAX)
Cannot adjust modulation
Cannot finish line probing normally No
Cannot finish equalizer training normally
Operator canceled the transmission Yes
Journal Redial
No F-Code Tx Error. No F-Code information in the remote
machine.
F-Code Tx Error. The Box does not exist in the remote
machine.
F-Code Tx Error. No document for polling is stored in F-
Code box.
Check condition of remote fax.
F-Code Polling error. Cannot access the F-Code box.
No High-speed RDS. Cannot send a data.
Cannot send a trouble report. Remote machine is not RDS
host.
Cannot receive with minimum speed.
No Scanning error. Please send again.
Only at Confirm the remote fax.
memory Tx
The remote machine could not receive document.
No
No Confirm the remote fax.
No
Cannot receive with minimum speed.
No Cannot send a fax in SuperG3 mode.
Yes
Fax job was cancelled by user.
No
4-8
Message
This error occurs at manual
reception.
This error occurs at manual
reception.
Note