Printer Fuser - Muratec MFX-2550 Field Engineering Manual

PRINTER FUSER

1. Open the Cover jam access.
2. Remove five screws [1].
3. Disconnect two connectors [2] and remove the PRINTER FUSER [3].
Caution
• Before removing the Printer fuser, make sure the power cord is unplugged. Failure to do so may result
in electrical shock.
• Make sure the Printer fuser become cool before removing it. The Roller heat is extremely HOT
immediately after operation and may cause burns.
• Do not touch the thermostat or thermal fuse while performing this procedure.
[ 2 ]
[ 2 ]
[ 1 ]
[ 1 ]
5-102
[ 1 ]
[ 1 ]
[ 1 ]
[ 3 ]