Muratec MFX-2550 Field Engineering Manual page 54

Service Program
Life monitor
maintenance
Sensor input test
Printer diagnostic
mode
Network service mode Used to clear administrator's password and
Flash ROM Sum
check
Set service report
Printer registration
adjustment
Reset printer trouble
Cleaning mode
Key Counter
Network switch mode Adjust the network parameter.
Touch Panel Adjust-
ment
Printer control param-
eter mode
Network Capture
Storage Maintenance This mode is used to erase or initialize the
Coverage Rate
Service function menu All the field service program modes are avail-
Wire cleaning warning This mode makes to display the cleaning
Installing language
Counter Information
Maintenance
Asset Number
Update the software
Quick initial settings
Explanation
Use this mode to clear the resettable counter
or reenter the life monitor.
This mode enables to confirm the sensor
status.
This mode enables to confirm the operation
of the printer parts.
initialize authentication method.
This mode enables to check Sum after the
Flash ROM version is updated.
Used to enter location where to send the ser-
vice report.
This mode adjusts the print position.
This mode clears the service call. Clear the
warning when the trouble is settled.
This mode rotate the Pickup roller and reg-
istration roller automatically so that you can
clean the surface of them.
This function is for "Foreign Device Interface"
option). If you have attached the key counter
to the machine activate this mode to let it
count the printed-paper.
Correct the X, Y on the touch panel.
Adjust functions of print controller.
You can capture the packet data the ma-
chine has sent and received, and download
it from the web browser or sent it to an e-mail
address.
Compact Flash (CF) memory card on Office-
Bridge.
You can set the toner coverage rate of pa-
per. This will be the base to calculate the
toner consumption of the users.
able from the menu.
warning for drum charge wire and print head
in a certain interval.
You can install, edit or delete languages
on the machine that is prepared in an USB
memory.
This mode is used to correct the counter
data on SRAM (main control panel) and CF
memory card.
This mode is used to input the asset number. <Setting>, <*>, <9>, <5> 3-143
Update main ROM, optional print controller
ROM and network board ROM using this
mode.
You can do the following setting with continu-
ously:
1. Initial settings
2. Consumable order sheet
<Setting>, <*>, <2>, <0> 3-119
<Setting>, <*>, <2>, <2> 3-121
<Setting>, <*>, <2>, <3> 3-122
<Setting>, <*>, <2>, <4> 3-123
<Setting>, <*>, <2>, <9> 3-124
<Setting>, <*>, <4>, <2> 3-124
<Setting>, <*>, <4>, <3> 3-126
<Setting>, <*>, <4>, <5> 3-127
<Setting>, <*>, <4>, <6> 3-127
<Setting>, <*>, <5>, <0> 3-128
<Setting>, <*>, <5>, <1> 3-128
<Setting>, <*>, <5>, <6> 3-133
<Setting>, <*>, <5>, <7> 3-133
<Setting>, <*>, <5>, <8> 3-136
<Setting>, <*>, <5>, <9> 3-139
<Setting>, <*>, <6>, <0> 3-141
<Setting>, <*>, <7>, <7> 3-141
<Setting>, <*>, <8>, <6> 3-142
<Setting>, <*>, <9>, <1> 3-142
<Setting>, <*>, <9>, <3> 3-143
<Setting>, <*>, <9>, <8> 3-144
<Setting>, <*>, <9>, <9> 3-144
3-2
Operation Page