Muratec MFX-2550 Field Engineering Manual page 112

• 3429 baud symbol rate when communicating at V.34
030
• 3200 baud symbol rate when communicating at V.34
• 3000 baud symbol rate when communicating at V.34
• 2800 baud symbol rate when communicating at V.34
• 2400 baud symbol rate when communicating at V.34
• ANSam output time
032
• Reception level at CED 2100 Hz
035
• The timing between V.34 handshake signals
037
• Show the lamp in error
040
• Conform the numbers of line on the front page and back page
043
• Enable measures for false detection of punch holes as a document
045
leading edge
• Enables measures for false detection of punch holes as a document
trailing edge
• Enable measures for false detection of punch holes as a document
leading edge
• Punch hole maximum size adjustment
• Smoothing in Hyper Fine (400 x 400 dpi) mode
050
• Smoothing in Super Fine (200 x 400 dpi) mode
• Smoothing in Fine mode
• Smoothing in Normal mode
• Give priority to "fit to paper"
051
• Printing margin adjustment
052
053 • Printer density adjustment
• CNG detection during OGM output in ANS Ready
067
• Number of detection DTMF
• Line monitor in Quick memory transmission
071
• Rx document to polling document
• DRAM back up
072
• Journal list printing order
075
• Key press time to activate sleep mode
• Print time-out on PCL text printing (at local printing)
077
• Print timeout on GDI (at local printing)
078
• Print timeout on PCL (at local printing)
079
• Print dialing error on journal
081
• Copy all data at "Copy Machine Settings"
082
• Print/Send the consumable order sheet when the drum is near end
085
• Print/Send the consumable order sheet when toner is near empty
• Receive time stamp position
• F4 paper length
095
• Respond warm-up condition as ready on SNMP
098
• Respond Sleep condition as ready on SNMP
• Enable Quick TWAIN
099
3-60