Machine Parameter Adjustment; Setting The Machine Parameters - Muratec MFX-2550 Field Engineering Manual

3.2 Machine Parameter Adjustment

3.2.1 Setting the Machine Parameters

These switches are used to program internal machine parameters. The primary back up battery main-
tains these settings if power is lost.
1. From standby, press <Setting>, <*>, <0>, <0>.
2. Press [Edit Parameters].
3. Call up the desired switch by pressing [ ] or [ ] , or by pressing the numeric keypad.
4. Select the desired parameter by pressing the box.
5. To navigate through the machine parameter settings:
•
The bits are ranged from 7 (left) to 0 (right).
•
Press [ ] or [ ] of the cursor key to move the cursor.
•
Press <0> or <1> on the numeric keypad, or [ ] or [ ], to change the bit value.
•
Press [Enter] to save the setting of the displayed parameter and return to the machine pa-
rameter edit screen.
•
Press [Back] not to save the setting of the displayed parameter.
6. If you want to set other machine parameters, repeat step 3-5. Otherwise, proceed to step 7.
7. Press <Reset> to return the machine to ready screen.
You can confirm the initial setting of each Machine parameter by the Machine Parameters List.
The Machine Parameters List will be printed by pressing [List Parameter].
3-3