Muratec MFX-2550 Field Engineering Manual page 192

3.33.2 Resetting storage
To reuse the CF memory card, perform "3.41 Update the software" and reinstall the program after this
operation.
1. Press <Setting>, <*>, <5>, <9>.
2. Press [Storage Reset].
3. Press [Yes].
4. The machine reboots from itself.
3.33.3. How to upgrade your OfficeBridge memory
When you upgrade the CF memory card, the settings and image data will not be copied to the new card
automatically. Follow the procedures described bellow:
1. Backup the image data in the CF memory card to a network folder using the "Document Backup" function
on OfficeBridge.
For details, refer to the OfficeBridge Guide section 3, "Backing Up Documents".
2. Set Unique switch 082 bit 6 to "1".
3. Export the machine settings to a USB memory using the "Mirroring" function on the control panel.
For details, refer to the Administrator's Guide section 2, "Mirroring the Machine Settings".
4. Replace the CF memory card to the new one.
5. When you restart the machine, you will be asked for the administrator's password. Enter the password.
(See "3.33.4 About Storage replacement operation".)
6. Import the machine settings from the USB memory using the "Mirroring" function.
7. Reset Unique switch 082 bit 6 to "0".
You cannot import the image data to the new CF memory card. The backup image data will be displayed
on OfficeBridge when the "Backup Document Display" function is enabled. For details, refer to OfficeBridge
Guide section 3, "Specifying the Backup Document Display".
3.33.4 About Storage replacement operation
In the following cases, the display asks you to enter the Administrator's password. In such cases, enter the
Administrator password of the former device.
• When CF memory card used by another machine is attached.
• When CF memory card is removed and updated.
• When either the main control board or the network board is replaced.
• When unique switch 82 bit 6 is set to "1" and the machine setting data are imported.
3-140