Registration Adjustment - Muratec MFX-2550 Field Engineering Manual

5.3.4 Registration adjustment

FBS registration (top)
Note: This adjustment must be made after the adjustments of printer registration (top and side) of the first cassette
and FBS zoom adjustments (vertical and horizontal) have been made.
Standard
0 ± 2.2 (mm)
Adjustment procedure
1. Load letter paper to the first cassette.
2. Place a Test Chart on the document glass.
3. Make a copy of it in the 1st cassette with 100 % magnification.
4. Check that the difference of width A and the copy of A (A') meets the specifications.
If the difference falls outside the specified range, perform the following steps to make the adjust-
ment.
5. Enter Machine Parameter mode. (See "3.2.1 Setting the Machine Parameters".)
6. Adjust the setting of Machine Parameter 018 to meet the specification.
If the width A is shorter than the standard, decrease value.
If the width A is longer than the standard, increase value.
Edge of the paper
Adjustment Tool
Machine parameter:018
A
5-138
Test Chart
Setting Range
– 2.70 ~ 2.70 (mm)
(0.0212 mm step)