PCB PSU
1. Remove the Cover option. (See COVER OPTION)
2. Open the Cover front. (See PCB NCU)
3. Remove one screw. (See PCB NCU)
4. Release two hooks and remove the Cover left. (See PCB NCU)
5. Disconnect the connector and remove the PCB NCU. (See PCB NCU)
6. Remove two screws [1], then pull the PCB PSU [2] out slightly and disconnect three connectors.
7. Remove the PCB PSU [2].
[ 1 ]
Important
The far end of the PCB PSU is engaged with the hook. When assembling, make sure to engage it with
the hook.
[ 2 ]
[ 1 ]
5-80