Roller Exit (Mfx-2550 Only) - Muratec MFX-2550 Field Engineering Manual

ROLLER EXIT (MFX-2550 only)

1. Remove the Cover connect. (See COVER CONNECT)
2. Remove the Cover option. (See COVER OPTION)
3. Remove the Cover shield. (See COVER SHIELD)
4. Remove the Cover back. (See COVER BACK)
5. Remove the Chassis FBS. (See PCB CONNECT LPH)
6. Remove the Cover left. (See PCB NCU)
7. Remove the Tray paper exit. (See PCB CONNECT LPH)
8. Open the Cover jam access. (See ASSY INTERLOCK)
9. Remove the Frame upper. (See ASSY INTERLOCK)
10. Remove two E-rings [1], then remove the Bearing D6 9 [2].
11. Loosen two screws [3] in the Guide fuser.
12. Remove the ROLLER EXIT [4] by sliding it.
[ 3 ]
[ 1 ]
Important
When assembling Bearing D6 9, make sure it is aligned with the notch in the Frame upper.
[ 3 ]
[ 4 ]
5-108
[ 1 ]
[ 2 ]