SHAFT ROLLER PRESS/ROLLER EXIT (MFX-2570 only)
1. Remove the Cover connect. (See COVER CONNECT)
2. Remove the Cover option. (See COVER OPTION)
3. Remove the Cover shield. (See COVER SHIELD)
4. Remove the Cover back. (See COVER BACK)
5. Remove the Chassis FBS. (See PCB CONNECT LPH)
6. Remove the Cover left. (See PCB NCU)
7. Remove the Frame upper. (See ASSY INTERLOCK)
8. Remove the two screws [1], and then remove the Guide shift unit [2], Supported gear [3], Gear 20 [4],
parallel pin [5], and two Bearings D6 9 [6].
9. Remove the Rack shift unit [7], Shaft roller press [8], and Roller exit [9] all together.
10. Remove the SHAFT ROLLER PRESS [8] from the Rack shift unit [7].
* When doing so, be careful because the plate spring [10] and the coil spring [11] will come off at the
same time.
11. Remove one E-ring [12], then remove the ROLLER EXIT [9].
[ 1 ]
[ 12 ]
[ 7 ]
[ 2 ]
[ 9 ]
[ 8 ]
[ 6 ]
[ 5 ]
[ 1 ]
[ 4 ]
[ 3 ]
[10]
[11]
5-109