ROLLER FEED A
1. Remove the DADF cover TX. (See DADF COVER TX)
2. Remove the DADF frame scanner. (See DADF FRAME SCANNER)
3. Remove the DADF guide inner A. (See DADF GUIDE INNER A)
4. Remove the DADF guide inner B equipped with DADF DRIVE. (See DADF GUIDE INNER B equipped
with DADF DRIVE)
5. Remove the Gears (front). (See GEARS (FRONT))
6. Remove the Stay drive sensor and Clutch. (See CLUTCH)
7. Remove the Frame motor. (See MOTOR (STEPPING))
8. Remove the Gears (back). (See GEARS (BACK))
9. Remove the two screws [1] and two hooks [2], then remove the Guide inner B [3].
10. Remove the two screws [4], then remove the Bracket DS2 [5].
11. Pull the harness [6] out through the hole.
12. Remove the Guide inner D [7].
13. Remove one E-ring [8] and Bearing D6 [9].
[ 1 ]
[ 7 ]
[ 3 ]
[ 1 ]
[ 4 ]
[ 2 ]
[ 5 ]
[ 4 ]
[ 2 ]
[ 6 ]
[ 9 ]
[ 8 ]
5-53