Muratec MFX-2550 Field Engineering Manual page 408

ADF registration (side)
A
Edge of
the paper
Note: This adjustment must be made after the adjustments of printer registration (top and side) of the first cassette
and ADF zoom adjustments (vertical and horizontal) have been made.
Standard
0 ± 2.9 (mm)
Adjustment procedure
1. Load letter paper to the 1st cassette.
2. Place a Test Chart on the ADF.
3. Make a copy of it in the 1st cassette with 100 % magnification.
4. Check that the difference of width A and the copy of A (A') meets the specifications.
If the difference falls outside the specified range, perform the following steps to make the adjust-
ment.
5. Enter Machine Parameter mode. (See "3.2.1 Setting the Machine Parameters".)
6. Adjust the setting of Machine Parameter 010 to meet the specification.
If the width A is shorter than the standard, decrease value.
If the width A is longer than the standard, increase value.
Adjustment Tool
Machine parameter:010
5-141
Test Chart
Setting Range
– 10.76 ~ 10.76 (mm)
(0.0847 mm step)