PCB LED-LAMP DADF
1. Open the DADF cover TX. (See DADF FRAME SCANNER)
2. Remove the DADF frame scanner. (See DADF FRAME SCANNER)
3. Remove the Cover lower scanner. (See PCB RS)
4. Remove one screw [1] and one screw on the rear [2], then remove the Plate FG DADF [3].
5. Remove the two screws [4].
6. Disconnect the connector [5] and remove the Holder PCB LED ADF [6].
7. Remove the three Springs P LED PCB [7], then remove the PCB LED-LAMP DADF [8].
[ 1 ]
[ 4 ]
[ 3 ]
[ 7 ]
[ 4 ]
[ 2 ]
[ 7 ]
[ 8 ]
[ 7 ]
[ 6 ]
[ 5 ]
5-34