Muratec MFX-2550 Field Engineering Manual page 223

Detail
Phase Error code
Error code
Rx Phase B R.1.2 2116
2117
2118
2119
211A
211B
R.2.3 2023
Rx Phase C R.3.1 2031
R.3.3 2033
R.3.4 2034
R.3.6 2036
R.4.4 2044
R.4.1 2041
Rx Phase D R.4.2 2042
R.5.1 2051
R.5.2 2052
Rx V34 start up R.8.1 2081
2800
2801
2802
2803
R.8.10 208A
R.8.11 208B
Description
The F-code box stores document to its Yes
maximum capacity
Reception rejected while storing or
clearing documents
Reception rejected while printing docu-
ments
Cannot delete document for overwrite at
overwrite mode
Cannot update Flash ROM through com-
munication
Cannot fast remote diagnose
No answer to FTT
No answer to CFR
Yes
DCN received
Hang up
Continuous error line detected
DCN received to TT
FRTN output
Memory overflow
Too long document received
Cannot receive MPS/EOM/EOP
Yes
Cannot receive RR
DNC received
Error occurred while ECM data mode
V8 process did not finished normally Yes
Primary channel instruction did not
match at V8 mode
Primary channel instruction did not
match at V8 mode (TX FAX)
Primary channel instruction did not
match at V8 mode (RX FAX)
Cannot adjust modulation
Cannot finish line probing normally No
Cannot finish equalizer training normally
Journal Redial
No F-Code Rx Err. The F-Code box is full.
F-Code Rx Err. Cannot access the F-Code box
Machine error.
Reception was stopped.
No High-speed RDS. Cannot receive data.
Confirm the remote fax.
No Confirm the remote fax.
Reception was stopped.
Cannot receive with minimum speed.
Some pages are not received correctly.
Memory over.
Received doc. is not able to receive.
No Confirm the remote fax.
No Cannot send a fax in SuperG3 mode.
Yes at poll-
ing recep-
tion
Yes at poll-
ing recep-
tion
4-10
Message
Normally, this error does not
occur.
Document over 3m
Note