Gears (Front) - Muratec MFX-2550 Field Engineering Manual

GEARS (FRONT)

1. Remove the Tray document. (See TRAY DOCUMENT)
2. Remove the DADF cover TX. (See DADF COVER TX)
3. Remove the DADF frame scanner. (See DADF FRAME SCANNER)
4. Remove the DADF guide inner A. (See DADF GUIDE INNER A)
5. Remove the DADF guide inner B equipped with DADF DRIVE.(See DADF GUIDE INNER B equipped
with DADF DRIVE)
6. Remove one screw [1] and SR5 [2], then remove the Frame tension F [3], Tension pulley [4], and Spring
C tension F [5].
7. Remove the three E-rings [6], then remove the two Pulleys 24 6 [7], P pin 2 x 10 [8], and Belt (timing) [9].
8. Remove two Bearings D6 [10] and one Bearing D6 8 [11].
9. Remove the two screws [12], then remove the Plate hinge inner A [13].
10. Remove one SR5 [14], then remove the Torque-limiter [15] and GEAR 36 0.8 [16].
[ 8 ]
[ 12 ]
[ 15 ]
[ 13 ]
[ 12 ]
[ 16 ]
[ 8 ]
[ 10 ]
[ 11 ]
[ 7 ]
[ 10 ]
[ 9 ]
[ 7 ]
[ 6 ]
[ 14 ]
5-45
[ 6 ]
[ 6 ] [ 3 ]
[ 1 ]
[ 5 ]
[ 4 ]
[ 2 ]