Network System Errors - Muratec MFX-2550 Field Engineering Manual

4.3.3 Network system errors

In case "OB sytem error" occurs, refer to the table below to address them.
Error
Trouble
code
300 Eternal reboot is
detected.
400 System data
clearing error
5XX Version
mismatching
error
1XXYY* System error
2XXYY* Setting data
initialize error
* : XX and YY are function returned values.
Trouble detail
The firmware detected an incorrect
status, and machine rebooted to
recover them automatically. When
this status is detected twice, this error
occurs.
You may better the auto-recover
process by updating the firmware. The
detail will be printed on the service
report with developer's code.
This error occurs with firmware or
hardware defect.
This error occurs when the machine
reboots from "User data clear" or "All
RAM clear", and an incorrect status is
detected.
This error occurs when an optional
CF memory card is attached to the
network board, and the firmware
version on the CF memory card and
network board do not match.
This error occurs with firmware or
hardware defect.
Firmware defect will be recovered by
updating it, but hardware defect needs
its replacement.
Occurs mainly when the data stored
on the CF memory card is corrupted.
You may recover it by updating the
firmware, if that does not work, clear
the data.
4-6
Detection timing Countermeasure
The machine 1. Update the
reboots while
ROM using the
rebooting at the USB memory
same timing. automatically.
2. Replace the storage
(HDD/CF card).
When the machine 1. Update the
is powered on.
ROM using the
USB memory
automatically.
2. Replace the storage
(HDD/CF card).
3. Replace the network
board.
When the machine 1. Update the
is powered on.
ROM using the
USB memory
automatically.
2. Replace the storage
(HDD/CF card).
When the machine 1. Update the
is powered on.
ROM using the
USB memory
automatically.
2. Replace the network
board.
3. Replace the main
control board.
When the machine 1. Update the
is powered on
ROM using the
USB memory
automatically.
2. Perform "All RAM
Clear".
3. Replace the storage
(HDD/CF card).
4. Replace the network
board.