Muratec MFX-2550 Field Engineering Manual page 107

Attribute 1 - Individual Autodialer Setting
Initial
Switch
Setting
7 1 Busy tone detection
0: No
1: Yes
6 0 Fallback pattern (bps)
Set at 0: 2 times 2 times 2 times 2 times 2 times
Set at 1: 4 times 1 times 1 times 1 times 1 times
Overseas mode
5 0
0: No
1: Yes
4 0 V.29 Echo Protect tone
0: No
1: Yes
3 1 Maximum transmit speed (kbps)
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
2 1 0
0
1 0 0
0
0 1
Adjust
2400 4800 7200
0 0 0 0 0
0 0 0 1 1
0 1 1 0 0
1 0 1 0 1
3-55
(Equivalent to Memory Switch 010)
Usage/Comments
Sets this switch to "0" if the ring tone of remote unit
is mistaken for a busy signal.
9600 14400
Re-enables echo suppression that is disabled by
the CED signal (2100 Hz). Also ignores the first DIS
signal and transmits the DCS signal in response to
the second DIS signal.
International telephone lines equipped with echo
suppression will cut the beginning portion of the
transmitted information which may cause the
receiver not to receive the training and data. To
protect the received image from degrading, a 0.5
second Echo Protect tone is placed prior to the
training using G3 high-speed modem training
(V.29).
0 0 1 1 1
1 1 0 0 0
1 1 0 0 1
0 1 0 1 0
1 1 1
0 1 1
1 0 0
1 0 1