Quick Initial Settings; Update The Software - Muratec MFX-2550 Field Engineering Manual

3.40 Quick Initial settings

At installation of this machine, you should set some parameters according to the following procedures.
You can do the following setting with continuously.
1. Initial settings
2. Consumable order sheet settings
3. Service Report settings
1. Press <Setting>, <*>, <9>, <9>.
See following pages, how to set-up each mode:
Initial setting : See "Scanner and Fax Guide".
Consumable order sheet : See "3.17 Consumable order sheet" on page 3-113.

3.41 Update the software

There are three choices to update the ROM:
• Using the USB memory
• Using the Network (operating through control panel)
• Using the Network (operating through web browser) (See page 3-158.)
There are three types of flash ROM to update:
• Main ROM
• Network ROM
• PCL ROM
In following cases, software cannot be updated. Check the machine in advance:
• The machine is in operation (scanning, printing, or sending fax etc.)
• The memory is in use by delayed transmission or for other reasons.
CAUTION
Do not turn the power off while updating the software. Doing so may damage the main control board.
3.41.1 Updating the software using an USB memory
Update the machine software using an ROM data prepared in an USB memory. You can either update it
automatically to the latest version : "Auto Update", or to the desired version by selecting the ROM version
manually : "Manual Update".
3-144