MOTOR (STEPPING)
1. Remove the Cover connect. (See COVER CONNECT)
2. Remove the Cover option. (See COVER OPTION)
3. Remove the Cover shield. (See COVER SHIELD)
4. Remove the Cover back. (See COVER BACK)
5. Remove the Chassis FBS. (See PCB CONNECT LPH)
6. Remove the Cover left. (See PCB NCU)
7. Remove the Tray paper exit. (See PCB CONNECT LPH)
8. Disconnect the connector [2] from the PCB LPH [1].
[ 1 ]
[ 2 ]
9. Remove the two screws [3], then remove the MOTOR (STEPPING) [4].
[ 4 ]
[ 3 ]
[ 3 ]
5-118