Muratec MFX-2550 Field Engineering Manual page 222

Detail
Phase Error code
Error code
Rx Phase B R.1.1 2011
R.1.2 2012
2100
2101
2102
2103
2104
2105
2106
2107
2108
2109
210A
210B
210C
210D
210E
210F
2110
2111
2112
2113
2114
2115
Description
T1 time-out error No, if no
page is
received at
auto recep-
tion
Compatibility error Yes
The receiver is a product of other maker
at closed communication
No pass code received at closed com-
munication
The receiver has no pass code field at
closed communication
Reception blocked because of junk fax
blocking function
Cannot receive sender's ID at junk fax
blocking function
Sender's ID is blank at junk fax blocking
function
Sender has no polling document stored
Cannot adjust communication data rate
Cannot adjust communication code (MH,
MR, MMR)
Cannot adjust communication code
(Normal, fine, super fine)
Cannot adjust ECM mode
Cannot adjust document width
Cannot adjust minimum communication
time
Cannot adjust document length
Cannot receive standard frame
Out-of -paper reception buffer error
Cannot receive error report at F-code
relay reception because wrong TSI
Cannot receive document because
sender has not polling ability
Cannot receive F-code document be-
cause of wrong sub address
The receiver has no box that matches
with the sender
Document was sent to a reception pro-
tected box
Reception rejected while receiving
document to that box on another line at
multi line reception
Journal Redial
No Confirm the remote fax.
No Confirm the remote fax.
Closed Tx Err. Remote fax is not compatible.
Close Rx error. No passcode stored in remote fax.
Close Rx error. Passcode unmatched.
Reject.
Reception was rejected by the block junk fax function.
Polling Rx error. No document for polling is stored in re-
mote fax.
Confirm the remote fax.
Confirm the remote fax.
Out of paper reception is full.
The F-Code RelayReception cannot be performed if fax
number is not stored.
F-Code Polling error. Remote machine does not have F-
Code polling function.
Confirm the remote fax.
F-Code Tx Err. The box does not exist in the machine.
F-Code Rx Err. The F-Code is set as the ban on reception.
F-Code Rx Err. Cannot access the F-Code box.
4-9
Message
Occurs at manual reception.
Normally, this error does not
occur.
Note