Setting for use with a closed network
For maximum communications security, use a closed network. This limits your
machine to only communicating with other Muratec fax machines which can "pre-
sent" the proper passcode.
Important: The passcode you use for closed network operation is not the same as
the protection passcode.
Once your machine is set up for a closed network, your machine will disconnect calls
coming in from fax machines other than Muratec fax machines.
To set your fax machine's closed network password:
1
Decide on the four-digit closed network passcode (0001–9999) you want to use.
Write it down, and put it in a safe place.
2
Press
,
, 0, 8, [Enter].
MENU
J
The
shows the current code:
LCD
3
Use the numeric keypad to enter the desired
four-digit closed network passcode.
4
Press [Enter] to save the setting.
Note: To turn off the closed network passcode and return to normal fax reception,
change the code to 0000 by repeating steps 1–4 and entering 0000 in step 3.
To set your fax machine to operate in a closed network:
1
Press
,
, 0, 9, [Enter].
MENU
J
The
shows your fax's current setting:
LCD
2
Select desired mode.
3
Press [Enter] to save the setting.
All manuals and user guides at all-guides.com
08.Passcode
Enter the passcode.
0000
Passcode
09.Closed Network
Use cursor to select
ON or OFF.
ON
OFF
Setting Block Junk Fax
Your fax machine's Block Junk Fax feature lets
rized incoming faxes ("junk fax"). But before you
how this feature works, to determine if it's right
tings for Block Junk Fax:
• Off — The feature isn't activated.
• Mode1 — Your fax machine checks whether t
number in your autodialer matches the last f
scriber
machine disconnects the call.
• Mode2 — This mode rejects any call from a n
match any number in the blocked numbers li
can hold up to 30 blocked numbers.
• Mode3 — This rejects numbers that are not in
bers that are in the blocked numbers list. Thi
:0000
autodialer for transmission to it, while still b
it in the blocked numbers list.
But before you activate the Block Junk Fax feat
Enter
• Not all fax machine owners enter their phone
With Block Junk Fax activated, your machine
machines.
• Access codes can cause confusion. — If an aut
such as long-distance codes, Block Junk Fax w
To set Block Junk Fax:
1
2
Enter
3
(the phone number part of the
ID
Press
,
, 1, 1, [Enter].
MENU
J
The
shows your fax's current setting:
LCD
Select desired mode.
Press [Enter] to save the setting.
What you do next depends on what you sel
in step 2:
• If you selected Off or Mode1, press
• If you selected either Mode2 or Mode3, g
).
TTI
RESE