Table of Contents
Advertisement
Syntax
spanning-tree tcnguard
no spanning-tree tcnguard
no - This command sets the tcnguard parameter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Interface Config
7.5
System Log Management Commands
7.5.1
Show Commands
7.5.1.1
show logging
This command displays logging.
Syntax
show logging
Default Setting
None
Command Mode
Privileged Exec
Display Message
Logging Client Local Port The port on the collector/relay to which syslog messages are sent
CLI Command Logging The mode for CLI command logging.
Console Logging The mode for console logging.
Console Logging Severity Filter The minimum severity to log to the console log. Messages with an
equal or lower numerical severity are logged.
Buffered Logging The mode for buffered logging.
Syslog Logging The mode for logging to configured syslog hosts. If set to disable logging stops to
all syslog hosts.
Terminal Monitor The mode for terminal logging.
- 222 -
Advertisement
Table of Contents
