Table of Contents
Advertisement
The parameter <group-mask> is the group mask for the group address. The optional keyword override
indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Syntax
ip pimsm rp-address <rp-address> <group-address> <group-mask> [override]
no ip pimsm rp-address <rp-address> <group-address> <group-mask>
<rp-address> - the IP Address of the RP.
<group-address> - the group address supported by the RP.
<group-mask> - the group mask for the group address.
no - This command is used to delete RP IP address for the PIM-SM router. The parameter
<rp-address> is the IP address of the RP. The parameter <group-address> is the group address
supported by the RP. The parameter <group-mask> is the group mask for the group address.
Default Setting
None
Command Mode
Global Config
9.6.2.6
ip pimsm
This command sets administrative mode of PIM-SM multicast routing on a routing interface to enable.
Syntax
ip pimsm
no ip pimsm
no - This command sets administrative mode of PIM-SM multicast routing on a routing interface to
disabled.
Default Setting
Disbaled
Command Mode
Interface Config
9.6.2.7
ip pimsm hello-interval
This command configures the transmission frequency of hello messages in seconds between PIM
enabled neighbors. This field has a range of 0 to 18000 seconds.
- 529 -
Advertisement
Table of Contents
