Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 960

11.9.2.2 Configuring PIM-DM Interface Configuration Page
Selection Criteria
Slot/Port - Select the Slot and port for which data is to be displayed or configured. Slot 0 is the base
unit. You must have configured at least one router interface before configuring or displaying data for
a PIM-DM interface, otherwise an error message will be displayed.
Interface Mode - Select enable or disable from the pulldown menu to set the administrative status of
PIM-DM for the selected interface. The default is disable.
Configurable Data
Hello Interval - Enter the number of seconds between PIM hello messages transmitted from the
selected interface. The default value is 30. Valid values are from (10 to 3600) .
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.9.2.3 Viewing PIM-DM Interface Summary Page
- 960 -