Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 54

all - This command represents all ports.
no - This command enables all ports.
Default Setting
Enabled
Command Mode
Global Config
7.2.1.11 description
This command is used to create an alpha-numeric description of the port.
Syntax
description <description>
no description
no - This command removes the description of the port.
Default Setting
None
Command Mode
Interface Config
7.2.1.12 mdi
The 10-Giga interface will not provide the following command.
i
This command is used to configure the physical port MDI/MDIX state.
Syntax
mdi {auto|across|normal}
no mdi
auto - This type is auto selecting cable type.
across - This type is only allowed the Across-over cable.
normal - This type is only allowed the Normal cable.
no - This command restore the port mode to Auto.
- 54 -