Table of Contents
Advertisement
Selection Criteria
Admin Mode - Selects the IP Filter admin mode for enable or disable.
Configurable Data
Filter Address 1~5 - Stations that are allowed to make configuration changes to the Switch.
Command Buttons
Submit - Send the updated screen to the switch. Changes take effect on the switch but these
changes will not be retained across a power cycle unless a save is performed.
11.5.5
Defining Secure Http Configuration
11.5.5.1 Secure HTTP Configuration Page
Selection Criteria
HTTPS Admin Mode - This field is used to enable or disable the Administrative Mode of Secure
HTTP. The currently configured value is shown when the web page is displayed. The default value is
disabled.
TLS Version 1 - This field is used to enable or disable Transport Layer Security Version 1.0. The
currently configured value is shown when the web page is displayed. The default value is enabled.
SSL Version 3 - This field is used to enable or disable Secure Sockets Layer Version 3.0. The
currently configured value is shown when the web page is displayed. The default value is enabled.
Configurable Data
HTTPS Port Number - This field is used to set the HTTPS Port Number. The value must be in the
range of 1 to 65535. Port 443 is the default value. The currently configured value is shown when the
web page is displayed.
HTTPS Session Soft Timeout - This field is used to set the inactivity timeout for HTTPS sessions.
The value must be in the range of (1 to 60) minutes. The default value is 5 minutes. The currently
configured value is shown when the web page is displayed.
HTTPS Session Hard Timeout - This field is used to set the hard timeout for HTTPS sessions. This
timeout is unaffected by the activity level of the session. The value must be in the range of (1 to 168)
hours. The default value is 24 hours. The currently configured value is shown when the web page is
displayed.
- 859 -
Advertisement
Table of Contents
