Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 180

Default Setting
Disabled
Command Mode
Interface Config
This command enables link status traps for all interfaces.
This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserver
i
enable traps linkmode' command.
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Default Setting
Disabled
Command Mode
Global Config
7.3.6.4 snmptrap <name> ipaddr <ipaddr> <snmpversion>
This command adds an SNMP trap name. The maximum length of the name is 16 case-sensitive
alphanumeric characters.
Syntax
snmptrap <name> ipaddr <ipaddr> <snmpversion>
no snmptrap <name> <ipaddr> <snmpversion>
<name> - SNMP trap name (Range: up to 16 case-sensitive alphanumeric characters).
<ipaddr> - an IP address of the trap receiver.
<snmpversion> - SNMP trap version.
no - This command deletes trap receivers for a community.
Default Setting
None
- 180 -