Table of Contents
Advertisement
Outgoing Interface(s) - The list of outgoing interfaces on which multicast packets for this
source/group are forwarded.
Up Time (secs)- The time in seconds since the entry was created.
Expiry Time (secs)- The time in seconds before this entry will age out and be removed from the
table.
RPF Neighbor - The IP address of the Reverse Path Forwarding neighbor.
Protocol - The multicast routing protocol which created this entry. The possibilities are:
PIM-DM
PIM-SM
DVMRP
Flags - The value displayed in this field is valid if the multicast routing protocol running is PIMSM.
The possible values are RPT or SPT. For other protocols a "------" is displayed.
Command Buttons
Search - Search the Mroute table for an entry matching the Source IP (if entered) and Group IP
address.
Refresh - Refresh the information on the screen with the present state of the data in the router.
11.8.3.4 Configuring Multicast Static Routes Configuration Page
Selection Criteria
Source - Select Create Static Route to configure a new static entry in the MRoute table, or select
one of the existing entries from the pulldown menu.
Configurable Data
Source IP - Enter the IP Address that identifies the multicast packet source for the entry you are
creating.
Source Mask - Enter the subnet mask to be applied to the Source IP address.
RPF Neighbor - Enter the IP address of the neighbor router on the path to the source.
Metric - Enter the link state cost of the path to the multicast source. The range is 0 - 255 and the
default is one. You can change the metric for a configured route by selecting the static route and
editing this field.
- 941 -
Advertisement
Table of Contents
