Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 940

11.8.3.2 Configuring Interface's Multicast Configuration Page
Selection Criteria
Slot/Port - Select the routing interface you want to configure from the dropdown menu.
Configurable Data
TTL Threshold - Enter the TTL threshold below which a multicast data packet will not be forwarded
from the selected interface. You should enter a number between 0 and 255. If you enter 0 all
multicast packets for the selected interface will be forwarded. You must configure at least one router
interface before you will see this field.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.8.3.3 Viewing Multicast MRoute Summary Page
This screen displays selected contents of the Mroute Table in tabular form. If there are no routes in the
table you will not be presented with the Selection Criteria.
Selection Criteria
Source IP - Enter the IP address of the multicast packet source to be combined with the Group IP to
fully identify a single route whose Mroute table entry you want to display or clear. You may leave this
field blank.
Group IP - Enter the destination group IP address whose multicast route(s) you want to display or
clear.
Non-Configurable Data
Incoming Interface - The incoming interface on which multicast packets for this source/group arrive.
- 940 -